2101 1.0

GSMC 0.18um VCC Detector The present IP is a VCC Detector (VDT) circuit which detects the core supply and then sends a corresponding control signal to level shift. In specific...

2102 1.0

GSMC 0.18um Voltage Detector This IP is a Voltage Detector (VDT) circuit for power management application. When the supply voltage (AVDD33) increases above the detection level (VT...

2103 1.0

SMIC 0.13um LVDS Receiver The LVDS Receiver IP is designed to support Single Link transmission between Host and Flat Panel Display with up to SXGA+ resolution and Dual Link tra...

2104 1.0

SMIC 0.13um LVDS Transmitter The LVDS transmitter converts 28-bit data into 4-pair LVDS data stream. A phase-locked transmit clock is transmitted in parallel with the data stream ...

2105 1.0

SMIC 0.13um 1.2v/3.3v APLL This IP is a programmable Analog PLL suitable for high speed clock generation. High speed VCO can run from 100MHz to 300MHz (If the analog power drops...

2106 1.0

SMIC 0.13um 1.2v/3.3v PLL This PLL is designed for audio clock generation. The reference clock is 13.5MHz crystal or the input clock. It supports 256*fs clock output and 384*fs...

2107 1.0

SMIC 0.13um 1.2v/3.3v PLL Specification This PLL is designed for audio clock generation. The reference clock is either 12MHz crystal or the input clock. It supports 256*fs clock output, wher...

2108 1.0

SMIC 0.13um 1.2v APLL This IP is a programmable Analog PLL suitable for generating system clock. It contains a PFD, Charge pump, 3rd order loop filter, a 1-64 input clock d...

2109 1.0

SMIC 0.13um 3.3v/1.2v Power Regulator Present IP devises a NO-CAP regulator which generates 1.2V voltage from 3.3V power supply and provides100mA plus loading current. Targeted in the SMIC...

2110 1.0

SMIC0.13um 3.3V POR The present IP is a Power On Reset (POR) circuit without any external resistor or capacitor. It supports a power supply range from 1.62V to 3.6V. A CL...

2111 1.0

SMIC 0.13um 3.3V Power On Reset Present Power on Reset generates system reset pulses (POR33) when the 3.3V power supplier (VIN33) is turned on. This IP can not operate stand-alone be...

2112 1.0

SMIC 0.18um 12-Bit 8 Input 1M/200k SAR ADC The analog-to-digital converter uses Successive Approximation Register (SAR) architecture to achieve 12-bit resolution. The ADC includes a core intern...

2113 1.0

SMIC 0.18um 1.8v APLL This IP is a programmable Analog PLL suitable for high speed clock generation. High speed VCO can run from 50MHz to 400MHz. By setting DM [5:0] and DN...

2114 1.0

SMIC 0.18¦Ìm 5v-3.3v/1.8v Power Regulator Based on SMIC 0.18¦Ìm 3.3v/1.8v Logic process, this design of Power Regulator is to provide both 3.3v and 1.8v power supplies which are regulated from...

2115 1.0

SMIC 0.18¦Ìm 1.8v/3.3v Power Switch The SMIC18_PSW_01 is a PMOS power switch between the main power supply and isolation area. It can support up to 20mA current with less than 20 mV volt...

2116 1.0

SMIC 0.18um Stereo Speaker Drivers The SMIC18_SPKDRIVER_01 specifies the design of stereo speaker drivers. The drivers defined in this specification use class-AB structure to reduce pow...

2117 1.0

SMIC 0.18um 3.3v-1.8v Power Regulator Power Regulator, also called Voltage Regulator, is an on-chip device which provides the suitable power supply for the core from an external high volta...

2118 1.0

IBM10SF 1.0v/2.5v APLL Brief Specification This IP is a programmable Analog PLL suitable for high speed clock generation. High speed VCO can run from 150MHz to 500MHz. By setting DM (3:0) and D...

2119 1.0

IBM10SF 1.0v/2.5v APLL This IP is a programmable Analog PLL suitable for high speed clock generation. High speed VCO can run from 300MHz to 900MHz. By setting DM (3:0) and D...

2120 1.0

IBM 65nm 12-bit 1M/200K Single/Differential 2.5v Rail to Rail SAR ADC This analog-to-digital converter (ADC) uses successive approximation register (SAR) architecture to achieve 12-bit resolution. The ADC includes intern...

2121 1.0

IBM 65nm 1.0/2.5V 32768Hz Crystal Oscillator This is a 32768Hz crystal oscillator specifically designed for ultra-low power application. The sole power supply is 3.3V, but it can be as low as 1.6...

2122 1.0

IBM 65nm 3.3v-1.0v Power Regulator This IP is a 3.3V to 1.0V power regulator in IBM 65nm 1.0V/2.5V process. It supports a large Vdd range (1.62V~3.6V) and a large output capacitance ran...

2123 1.0

IBM 65nm Analog 2-1 MUX This analog 2-1 MUX is designed for low speed application....

2124 1.0

IBM10SF 1.0v/2.5v 10bit R2R DAC The I65GV25_R2RDAC_01 specifies a 10-bit R2R DAC. At the output side a voltage-mode buffer is used to generate the output voltage and filter out the e...

2125 1.0

IBM 10SF 65nm 2.5v PLL This PLL is designed for audio clock generation. The reference clock is 12MHz, 13.5MHz or 19.2MHz, which can be either from crystal OSC or from intern...

2126 1.0

IBM 65nm 24bit Sigma-Delta DAC The I65GV25_DAC_01 specifies the design of a high-performance 24-bit stereo Audio DAC for portable digital audio systems. The DAC within the specifica...

2127 1.0

IBM 65nm 24-bit Stereo Sigma-Delta ADC The I65GV25_ADC_01 specifies the design of a high-performance 24-bit stereo Audio ADC for portable digital audio systems. The ADC within the specifica...

2128 1.0

SMIC 0.13um 1Channel 10Bit 10MHz DAC S13V33_R2RDAC_01 is a 10bit@10MHz DAC IP which implements a 7-bit (from D [0] to D [6]) R2R_Ladder and 3-bit thermometer decoder architecture. At the ...

2129 1.0

SMIC 0.13um 1.2v/3.3v PLL This PLL is designed for audio clock generation. The reference clock is either 12MHz crystal or the input clock. It supports 256*fs and 128*fs clock o...

2130 1.0

SMIC 0.13um 1.2v APLL This IP is a programmable Analog PLL suitable for generating system clock. High speed VCO can run from 250MHz to 500MHz. By setting DM [5:0] and DN [7...

2131 1.0

SMIC 0.13um 1.2v FN-PLL This IP is a programmable Analog PLL suitable for high speed clock generation. The high speed VCO can run from 200MHz to 500MHz. It contains a 1-64 in...

2132 1.0

SMIC 0.13μm 1.62~3.3v->1.2v Power Regulator Targeted in SMIC 0.13μm 1.2v/3.3v logic process, current design of Power Regulator is to provide 1.2v power supply which is regulated from the si...

2133 1.0

SMIC 0.13μm 1.62~3.3v->1.2v Power Regulator Targeted in SMIC 0.13μm 1.2v/3.3v logic process, current design of Power Regulator is to provide 1.2v power supply which is regulated from the si...

2134 1.0

SMIC 0.13um 3.3V/1.2V Power on Reset The present Power-On-Reset circuit generates system reset pulses (RST) when both the 3.3V and 1.2V power suppliers are turned on. Output signal RST12 ...

2135 1.0

SMIC 0.13um 1.2V Power On Reset Present Power on Reset generates system reset pulses (POR12) when 1.2V power supplier (VIN12) is turned on. This IP can not operate stand-alone becaus...

2136 1.0

SMIC 0.13um 1.2V Power On Reset Present Power on Reset generates system reset signal (POR12) when 1.2V power supplier (VIN12) is turned on. This IP can not operate stand-alone becaus...

2137 1.0

SMIC 0.13um 1.8V Power On Reset Present Power on Reset generates system reset signal (POR18) when 1.8V power supplier (VIN18) is turned on. This IP can not operate stand-alone becaus...

2138 1.0

SMIC 0.13um 3.3V Power On Reset Present Power on Reset generates system reset signal (POR33) when 3.3V power supplier (VIN33) is turned on. This IP can not operate stand-alone becaus...

2139 1.0

SMIC 0.13μm 1.2v 300MHz Ring Oscillator The present IP is a Ring Oscillator which is controlled by external bias current from bandgap. Its output frequency is about 300MHz and it can be fair...

2140 1.0

SMIC 0.18um 12-bit 1M/200K Single-Ended 3.3v Rail to Rail SAR ADC This analog-to-digital converter (ADC) uses successive approximation register (SAR) architecture to achieve 12-bit resolution. The ADC includes intern...

2141 1.0

SMIC 0.18um 1-Channel 12-bit 200K 3.3V Multi-Input SAR A This analog-to-digital converter (ADC) is a one-channel SAR ADC with multi-input PGA and bandgap. It is devised to replace the sigma-delta ADC used in...

2142 1.0

SMIC 0.18um MMC_07E To provide a solution to MMC cards, SMIC18_MMC_07E_4IN1 is consolidated by four independent IPs: SMIC18_PRG_03E_33T18V60_160mA, SMIC18_ROSC_01E_48M, S...

2143 1.0

SMIC 0.18um 1.8v APLL with Free Running This IP is a programmable Analog PLL suitable for high speed clock generation. Its high speed VCO can run from 100MHz to 250MHz. This IP has an import...

2144 1.0

SMIC 0.18um 1.8V/3.3V Power Switch The SMIC18_PSW_02 is a 3.3V PMOS power switch connecting the main supply and the core area. This IP includes a 3.3V input and a 3.3V output with one e...

2145 1.0

SMIC 0.18um 1.8V/3.3V Power Switch The SMIC18_PSW_02B is a 3.3V PMOS power switch connecting the main supply and the core area. This IP includes a 3.3V input and a 3.3V output with one ...

2146 1.0

SMIC 0.18um 1.8v Ring Oscillator The present IP is a Ring Oscillator. Its output frequency is about 96 MHz and the frequency can be fairly accurate (±10%) by trimming the resistance. ...

2147 1.0

GSMC0.18um Analog 2-1 MUX This analog 2 to 1 MUX is designed for low speed application...

2148 1.0

SMIC 0.11um 32KHz Crystal Oscillator Process: SMIC 0.11um Logic 1P8M 1.2V/3.3V CMOS process Operating voltage range: VCC_XO: 1.62~3.6V Operating temperature range: -40~125°C Operating ...

2149 1.0

SMIC 0.11um 1.2v APLL This IP is a programmable Analog PLL suitable for high speed clock generation. High speed VCO can run from 50MHz to 500MHz. By setting DM(5:0) and DN(...

2150 1.0

SMIC 0.13um 1.2v / 3.3v Audio PLL This PLL is designed for audio clock generation. The reference clock is 13.5MHz crystal or the input clock. It supports both 256X and 384X oversamplin...