4001 0.0

3.4 to 11 MHz 8rd order low pass filter The cell is the 8rd order Butterworth low pass filter with cut-off frequency adjustment. The block has two channels of differential inputs and outputs...

4002 0.0

Programmable 6-bit CMOS frequency divider The programmable 6-bit CMOS frequency divider is a set of two independent circuits. One of them is designed using 6-bit counter and is able to change ...

4003 0.0

-45 … +85°C Temperature sensor 180TSMC_TS_01 consists of built-in 10-bit R-2R DAC, diode and own reference voltage former. When requested, controller performs conversion of diode vo...

4004 0.0

3-6 GHz to 0.075-3 GHz Quadrature former 055TSMC_QF_02 is a quadrature former generating a differential quadrature signal in frequency range from 0.075 GHz to 3GHz. Input frequency range from...

4005 0.0

0.6V/10u, 20uA, 100nA, 200nA Reference voltage and current source 055TSMC_RS_05 is a reference voltage and current source that consists of bandgap voltage reference, two voltage-to-current converters and current-volt...

4006 0.0

10-bit 1-channel 1 MSPS SAR ADC 250iHP_ADC_09 is 10-bit 1 MSPS ADC employs high-performance single ended successive approximation architecture with embedded 8-input signal multiplexe...

4007 0.0

10-bit 1-channel constant power DAC 10-bit constant power DAC employs a current steering DAC architecture with control loop, which adjusts DAC input code to keep power dissipated in term...

4008 0.0

Power Management Unit (1.1 - 1.4V output voltage, load current 5 mA) 055TSMC_PMU_01 is designed to form stabilized voltage with overcurrent indication (bit Status). The block has configurable output voltage (1.1/1.2/1.3...

4009 0.0

3.3 - 4.2V to 0 - minus 200V step-down DC/DC converter 180XFAB_DCDC_04 is a DC/DC step-down voltage converter that generates -200V output voltage from 3.3V to 4.2V. The DC/DC consists of OTA and transistor...

4010 0.0

14-bit 1-channel 40 to 160 MSPS pipeline ADC 065STM_ADC_01 is a high-speed 1-channel 14-bit ADC based on a pipelined architecture. The ADC consists of three main blocks: the ADC, RS, and the cloc...

4011 0.0

12-bit 1-channel 5 to 100 kSPS SAR ADC 055TSMC_ADC_02 is a 12-bit 1-channel SAR ADC that designed to processing audio signals from linear microphone input. The block consists of SAR ADC cor...

4012 0.0

12-bit 1-channel 10 to 150 MSPS current steering DAC 055TSMC_DAC_03 is a 12-bit 1-channel DAC that uses a high-performance current control architecture and provides optional differential current output o...

4013 0.0

50MHz to 800MHz Integer-N Phase-Locked Loop 055TSMC_PLL_03 is a PLL frequency synthesizer that generates two clock signals in the range from 1 MHz to 50MHz. The synthesizer consists of one volta...

4014 0.0

NFC Power Management Unit (1.08 – 1.32 V output voltage, 50 nA output current) 130GF_PMU_01 is a Power Management Unit (PMU) block designed to supply embedded integrated circuits with stable and precise voltage, current and clock...

4015 0.0

12-bit 1-channel up to 1 MSPS low power SAR ADC 055GF_ADC_02 is a low power 12-bit 1-channel ADC that uses a SAR architecture. The block consists of SAR ADC core and bias block The ADC settings allo...

4016 0.0

8-channel 8-bit voltage comparator 028TSMC_COMP_01 is a comparator that compares a reference voltage to an analog input voltage and contains 8 input channels with a programmable thresho...

4017 0.0

16-bit 2-channel 312.5kSPS delta-sigma ADC 028TSMC_ADC_02 is analog ADC based on 4th-order sigma-delta modulator with fully differential/single-ended signal processing. Second order discrete ti...

4018 0.0

5 mA LDO voltage regulator (output voltage 1.1V/1.2V/1.3V/1.4V) 055TSMC_LDO_01 is a low drop out voltage regulator designed to supply integrated circuits with stable and precise voltage. The LDO inputs voltage VDD_...

4019 0.0

NFC Power Management Unit (0.6/1.2/1.5 V output voltage, 10/20/50 uA output current, 2 MHz output clock frequency) 130GF_PMU_02 is a Power Management Unit (PMU) block designed to supply embedded integrated circuits with stable and precise voltage and current. IP sh...

4020 0.0

UHF RFID EPC Gen2 physical interface 130GF _G2PHY_02 is the IP intended for use in passive UHF transponder applications. IP derives its operating power from an RF electromagnetic field ge...

4021 0.0

20 mA LDO voltage regulator (output voltage 1.1V/1.2V/1.3V/1.4V) 055TSMC_LDO_09 IP is cap-based LDO voltage regulator designed to convert IO voltage 2.5V to 1.2V and supply analogy circuits with load up to 20mA. The...

4022 0.0

20 to 50 MHz crystal oscillator 055TSMC_OSC_01 is a reference frequency generator designed to form a reference signal in the frequency range from 10 to 50MHz. The block consists of a...

4023 0.0

10MHz to 50MHz Fractional-N Phase-Locked Loop APLL Fractional-N phase locked loop frequency synthesizer is intended for SoC clock generation and embeds a reference 10MHz – 50MHz XTAL oscillator, w...

4024 0.0

5mA LDO voltage regulator (output voltage value 1.15V/1.2 V/1.25V/1.3V) with BG (0.6V) and I2V (5uA, 10uA, 20uA, 50uA) 130GF_LDO_03 is a Power management unit, designed to supply integrated circuits with stable and precise voltage. IP includes Bandgap block (BG), Volta...

4025 0.0

20mA low noise LDO voltage regulator (output voltage 1.1V/1.2V/1.3V/1.4V) 055TSMC_LDO_08 IP is low noise cap-based LDO voltage regulator designed to convert IO voltage 2.5V to 1.2V and supply analogy circuits with load up to...

4026 0.0

32.768 kHz crystal oscillator 055SMIC_OSC_01 is a reference frequency generator, designed to form a reference signal with the precise frequency 32.768kHz. The oscillator is a CMO...

4027 0.0

5 MHz RC oscillator 055SMIC_OSC_02 is a low power RC oscillator nominally operates at 5MHz output clock from a 1.2V supply. The oscillator operates in a voltage range of ...

4028 0.0

12-bit 1-channel up to 100kSPS low power SAR ADC 130GF_ADC_01 is a 12 bit, 1-channel, low power SAR ADC with sampling rates up to 100 kSPS. The ADC has two operating modes: single-shot conversion a...

4029 0.0

20mA and 500mA LDO voltage regulators (output voltage 2.5V) 055TSMC_LDO_06 is a cap-based LDO voltage regulator designed to supply integrated circuits with stable and precise voltage. 2.5V. The LDO converts IO ...

4030 0.0

24-bit 1-channel 44.1 to 48kSPS delta-sigma ADC 180XFAB_ADC_01 is a 24-bit delta-sigma ADC with sampling rates from 44.1kSPS to 48kSPS. Two second order feedforward modulators are used to create f...

4031 0.0

5.8GHz Fractional-N PLL synthesizer 130GF_PLL_02 is intended for SoC clock generation with support of BFSK modulation up to 4Mbps output data rate. PLL IP block embeds a reference 8MHz/1...

4032 0.0

3.3V to 2.5V 50mA LDO voltage regulator 028SAM_LDO_05 is external-capacitor-based Linear Regulator in Samsung 28 LPP to generate SoC voltage supply voltage. The block provided with stable an...

4033 0.0

14-bit 1-channel 40 to 125 MSPS pipelined ADC 055TSMC_ADC_15 is a high-speed 14-bit ADC, employs a high-performance differential pipeline architecture. This ADC consist of 14-bit pipelined ADC cor...

4034 0.0

27.12 MHz crystal oscillator 180TSMC_OSC_05 is a reference frequency generator designed to form a 27.12 MHz reference signal. The reference signal indicator informs the control sy...

4035 0.0

1GHz to 3GHz, 6MHz to 100MHz Fractional-N Phase-Locked Loop 180TSMC_PLL_10 is designed to generate a high frequency signal in a range from 1GHz to 3GHz and a low frequency clock signal in a range from 6MHz to 1...

4036 0.0

JTAG 2-Wire to 4-Wire Adapter The OT4001_cjtag is an adapter which permits legacy IEEE 1149.1 ports to communicate as an IEEE 1149.7 2-wire OScan1 cJTAG port. A simple update to a ...

4037 0.0

Combined Voltage and Current Reference The OT0118 is a medium precision, trimmed bandgap voltage reference and temperature compensated current reference generator....

4038 0.0

UMC L40G 40nm DDR DLL - 316MHz-1580MHz The DDR DLL uses a reference clock to establish a time base in order to delay arbitrary (nonperiodic) strobe signals by precise fractions of the clock...

4039 0.0

UMC L40G 40nm DDR DLL - 200MHz-1000MHz The DDR DLL uses a reference clock to establish a time base in order to delay arbitrary (nonperiodic) strobe signals by precise fractions of the clock...

4040 0.0

UMC L40G 40nm DDR DLL - 150MHz-750MHz The DDR DLL uses a reference clock to establish a time base in order to delay arbitrary (nonperiodic) strobe signals by precise fractions of the clock...

4041 0.0

PVT - Process, Voltage, and Temperature Monitor with Interrupt 7nm/6nm The ODT-PVT-ULP-001C-7 is an ultra-low power temperature, voltage and process monitor designed in a 7nm/6nm CMOS process. This IP operates over the en...

4042 0.0

Low Dropout (LDO) Capless Regulator The ODT-LDO-IC-300M-7 is a low dropout (LDO), linear regulator for integration in a SoC. The LDO uses advanced control techniques to achieve excellent...

4043 0.0

UMC L40LP 40nm DDR DLL - 177MHz-885MHz The DDR DLL uses a reference clock to establish a time base in order to delay arbitrary (nonperiodic) strobe signals by precise fractions of the clock...

4044 0.0

1MHz-50GHz Programmable Prescaler - Divider by 1/2/4/8/16 in SiGe The PMCC_DIV50G1_16 is a high speed (up to 50GHz) fully differential programmable divider IP block, designed using Jazz SiGe120 (SBC18HX) technology. ...

4045 0.0

24GHz VCO in SiGe The PMCC_VCO20G /24G /25G /26G /30G is a set of fully differential high speed VCOs covering 20GHz … 30GHz frequency range, designed using Jazz SiGe120...

4046 0.0

Band-gap Reference in GF N65 LP. Multiple voltages referenced to internal and external resistors. The PMCC_REFS IP block combines two modules of GM current references and one module of BG (band-gap) current reference. Each module provides up to twe...

4047 0.0

Differential CML 50 Ohm terminated output Buffer for up to 12Gb/s (GF N65) The PMCC_OBUF12G is a differential CML 50Ω terminated output driver for datarates from DC up to 12Gb/s. The buffer can also be used for up to 8...

4048 0.0

UMC L40LP 40nm DDR DLL - 112MHz-560MHz The DDR DLL uses a reference clock to establish a time base in order to delay arbitrary (nonperiodic) strobe signals by precise fractions of the clock...

4049 0.0

UMC L40LP 40nm DDR DLL - 84MHz-420MHz The DDR DLL uses a reference clock to establish a time base in order to delay arbitrary (nonperiodic) strobe signals by precise fractions of the clock...

4050 0.0

UMC L55LP 55nm DDR DLL - 164MHz-820MHz The DDR DLL uses a reference clock to establish a time base in order to delay arbitrary (nonperiodic) strobe signals by precise fractions of the clock...