Design & Reuse
1878 IP
1151
1.0
PCIe2.1 PHY
The Innosilicon SERDES PHY is a highly configurable PHY capable of supporting speeds up to 25Gbps within a single lane. For this particular datasheet,...
1152
1.0
PCIe3.0 Controller
The Innosilicon Gen1/2/3 PCI Express Controller provides a PCI Express Root Complex (RC) and Endpoint (EP) application. It’s a high performance, high ...
1153
1.0
PCIe3.0 PHY
The Innosilicon PCIe3.0 PHY is a highly configurable PHY capable of supporting speeds up to 8Gbps within a single lane. For this particular datasheet,...
1154
20.0
MIPI D-PHY Universal IP in TSMC 28HPC+
The MXL-DPHY-UNIV-T-28HPC+ is a high-frequency, low-power, low-cost, source-synchronous, physical Layer supporting the MIPI Alliance Specificatio...
1155
1.0
PCIe4.0 Controller
The Innosilicon Gen1/2/3/4 PCI Express Controller provides a PCI Express Root Complex (RC) and Endpoint (EP) application. It’s a high performance, hig...
1156
1.0
PCIe4.0 PHY
The Innosilicon PCIe4.0 PHY is a highly configurable PHY capable of supporting speeds up to 16Gbps within a single lane. For this particular datasheet...
1157
1.0
PCIe5.0 PHY & Controller
The Innosilicon Gen1/2/3/4/5 PCI Express Controller provides a PCI Express Root Complex (RC) and Endpoint (EP) application. It’s a high performance, h...
1158
1.0
SGMII PHY
The Innosilicon SGMII PHY is a highly programmable module that processes high-speed serial data to parallel data compatible with the IEEE802.3 1000BAS...
1159
1.0
PCIe4/3/2/1 PHY & Controller
The Innosilicon PCIe4.0 PHY is a highly configurable PHY capable of supporting speeds up to 16Gbps within a single lane. For this particular datasheet...
1160
6.0
USB 2.0 Host Controller
The USB 2.0 Host Controller core (GRUSBHC) provides a link between the AMBA on-chip bus and the Universal Serial Bus (USB). The host controller suppor...
1161
6.0
USB 2.0 Device Controller
The Universal Serial Bus Device Controller provides a USB 2.0 function interface accessible from an AMBA-AHB bus interface. The core must be connected...
1162
1.0
Type-C PHY
Innosilicon Type-C IP is composed of the physical layer and the PHY logic. The physical layer contains 4 data channels, an AUX channel and bias circui...
1163
1.0
USB3.1/3.0 PHY & Controller
The Innosilicon USB3.0 PHY is a highly programmable module that processes high-speed serial data to parallel data compatible with the PHY Interface fo...
1164
1.0
USB 3.0 DRD Controller
Innosilicon USB3.0 DRD Controller provides a USB3.0-compliant host/device controller solution. This controller can be programmed to support data trans...
1165
25.0
MIPI D-PHY CSI-2 RX+ IP in TSMC 28HPC+ for Automotive Applications
The MXL-DPHY-CSI-RX+-T-28HPC+ is a high-frequency, low-power, low-cost, source-synchronous, physical Layer supporting the MIPI Alliance Specification ...
1166
1.0
USB2.0 OTG PHY
The INNO USB 2.0 PHY conforms to the specification of UTMI+ level 3 Revision 1.0 (USB 2.0 Transceiver Macrocell Interface Plus) and has excellent perf...
1167
1.0
USB2.0 PHY & Controller
The INNO USB 2.0 PHY conforms to the specification of UTMI+ level 3 Revision 1.0 (USB 2.0 Transceiver Macrocell Interface Plus) and has excellent perf...
1168
1.0
USB 2.0 DRD Controller
Innosilicon USB2.0 DRD Controller provides a USB2.0-compliant host/device controller solution. This controller can be programmed to support data trans...
1169
1.0
USB3.2 PHY
The Innosilicon USB3.2 PHY is a highly programmable module that processes high-speed serial data to parallel data compatible with the PHY Interface fo...
1170
30.0
USB2.0 PHY, 8-bit or a 16-bit parallel interface, remaining backward compatible with USB1.1 legacy protocol at 12Mbps
KA13UGUSB20ST001 is USB2.0 physical layer transceiver (PHY) integrated circuits. The PHY can be configured for either an 8-bit or a 16-bit parallel in...
1171
2.0
AMBA interface for Actel MIL-STD-1553B Cores
The GR1553 is a set of AMBA AHB/APB wrappers for the Actel AX/RTAX MIL-STD-1553B cores. Wrappers for the following Actel cores are provided: Core1553B...
1172
6.0
Spacewire Codec with AHB host interface
The GRSPW core implements a Spacewire Codec with RMAP support and AMBA host interface. The core implements the Spacewire standard with the protocol id...
1173
6.0
10/100 Mbit Ethernet MAC
The GRETH core implements 10/100 Mbit/s Ethernet Media Access Controller (MAC) with AMBA host interface. The core implements the 802.3-2002 Ethernet s...
1174
2.0
Advanced Encryption Standard (AES-128) core with AMBA AHB interface
The GRAES core implements the Advanced Encryption Standard (AES) symmetric encryption algorithm for high throughput application (like audio or video s...
1175
2.0
Elliptic Curve Cryptography (ECC) core with AMBA APB interface
The GRECC core implements Elliptic Curve Cryptography (ECC) which is used as a public key mechanism and is well suited for application in mobile commu...
1176
0.0
PCI to AMBA AHB Host Bridge
This PCI Host Bridge IP core enables data transfers between an AMBA® AHB host processor bus system and PCI bus based devices. The bridge enables high...
1177
10.0
USB 3.0 femtoPHY in UMC (28nm, 12nm)
The Synopsys USB-C™ 3.0 and USB 3.0 femtoPHY IP provide designers with a complete physical (PHY) layer IP solution for low-power mobile and consumer a...
1178
10.0
MIPI D-PHY CSI-2 TX (Transmitter) 2.5Gbps in TSMC 65LP
The MXL-DPHY-2p5G-CSI-2-TX-T-65LP is a high-frequency, low-power, low-cost, source-synchronous, physical Layer supporting the MIPI Alliance Specific...
1179
2.0
Bi-directional AMBA AHB/AHB bridge
The bi-directional AHB/AHB Bridge is used to interconnect high-speed and low-speed AMBA AHB buses. The bridge supports synchronous clocks with any fre...
1180
2.0
Uni-directional AMBA AHB to AHB bridge
The Uni-directional AHB to AHB bridge is used to connect two AHB buses clocked by synchronous clocks with any frequency ratio. The bridge is connected...
1181
4.0
SATA Host Controller
HCLSATAHC26113G core handles data movement between system memory and a SATA device. The core implements transport layer & link layer functions. HCLSA...
1182
4.0
I2C Controller (AMBA APB <-> I2C)
The I2C Controller provides access to devices with I2C interface. It accepts the Read / Write commands from APB and converts it to the serial I2C acce...
1183
4.0
AHB Compliant Nand Flash Controller
NAND Flash Controller has a built-in AHB Slave Interface, handles all sorts of Nand Flash commands, address & data sequences. It allows the users to a...
1184
4.0
AHB to APB Bridge
The AHB to APB bridge is an AHB slave, providing an interface between the highspeed AHB and the low-power APB. Read and write transfers on the AHB are...
1185
4.0
DDR3 Controller IP
The AXI DDR3 Controller provides access to DDR3 memory. It accepts the Read / Write commands from AXI and converts it into DDR3 access. While doing th...
1186
1.0
DP1.1 RX PHY
Innosilicon DP RX PHY is designed to receive and recover the video, audio and auxiliary data from a DP or eDP source device for display applications. ...
1187
1.0
DP1.2 RX PHY
Innosilicon DP RX PHY is designed to receive and recover the video, audio and auxiliary data from a DP or eDP source device for display applications. ...
1188
100.0
MIPI C-PHY/D-PHY Combo RX+ IP (4.5Gsps/4.5Gbps) in TSMC N5
The MXL-CD-PHY-CSI-RX+-T-N05 is a high-frequency, low-power, low-cost, source-synchronous, physical Layer supporting the MIPI Alliance Specification ...
1189
1.0
DP1.2 Transmitter PHY_40nm
Innosilicon DP TX IP is designed to transmit video, audio and auxiliary data from system host device to a display device for display applications. Inn...
1190
1.0
DP1.4 Receiver Controller
This document describes the low power Innosilicon DP 1.4 Receiver controller, which is fully compliant with DP 1.4 specification and eDP 1.4 standard....
1191
1.0
DP/eDP1.4/1.2 RX PHY
Innosilicon DP RX PHY is designed to receive and recover the video, audio and auxiliary data from a DP or eDP source device for display applications. ...
1192
1.0
DP1.4 TX PHY
Innosilicon eDP TX PHY is designed to transmit video, audio, and auxiliary data from a system host device to a display device for display applications...
1193
1.0
DP/eDP1.4/1.2 TX PHY&controller
Innosilicon eDP TX PHY is designed to transmit video, audio, and auxiliary data from a system host device to a display device for display applications...
1194
1.0
eDP1.4 Transmitter PHY
Innosilicon eDP TX IP is designed to transmit video, audio and auxiliary data from system host device to a display device for display applications. In...
1195
1.0
HDMI1.4 Receiver PHY
Innosilicon HDMI RX IP is designed to receive and recover the video and audio data from an HDMI source device for display applications. Innosilicon HD...
1196
1.0
HDMI1.4 Transmitter IP
Innosilicon HDMI TX IP is designed for transmitting video and audio data from a video source device to a display device, which is compatible with HDMI...
1197
1.0
HDMI2.0/1.4 RX PHY & Controller
Innosilicon HDMI RX IP is designed to receive and recover the video and audio data from a HDMI source device for display applications, which is compat...
1198
1.0
HDMI2.0 Receiver PHY
Innosilicon HDMI RX IP is designed to receive and recover the video and audio data from an HDMI source device for display applications. Innosilicon HD...
1199
76.0
MIPI C-PHY/D-PHY Combo TX+ IP 4.5Gsps/4.5Gbps in TSMC N5
The MXL-CDPHY-DSI-TX+-T-N05 is a high-frequency, low-power, low-cost, source-synchronous, physical Layer supporting the MIPI Alliance Specification fo...
1200
1.0
HDMI2.0 Receiver PHY & Controller
Innosilicon HDMI RX IP is composed of the digital controller, the PHY logic and physical layer. The digital controller receives video, audio, synchron...