Design & Reuse
arrow A/D Converter (ADC) (531)
arrow Amplifier (102)
arrow Analog Comparator (21)
arrow Analog Filter (27)
arrow Analog Front Ends (38)
arrow Analog Multiplexer (3)
arrow Analog Subsystems (3)
arrow Clock Synthesizer (83)
arrow Coder/Decoder (CODEC) (107)
arrow D/A Converter (DAC) (222)
arrow DC-DC Converter (67)
arrow DLL (743)
arrow Graphics & Video Modules (5)
arrow Oscillator (342)
arrow Oversampling Modulator (8)
arrow PLL (1723)
arrow Power Management (855)
arrow RF Modules (82)
arrow Sensor (39)
arrow Sensors and Monitors (45)
arrow Switched Cap Filter (1)
arrow Temperature Sensor (143)
arrow Other (497)
5687 IP
2301
1.0
GSMC 0.13um 1.5v APLL
This IP is a programmable Analog PLL suitable for high speed clock generation. Its high speed VCO can run from 60MHz to 160MHz. The output frequency i...
2302
1.0
CSMC 0.13um 3.3v RC Oscillator
The present IP is a RC oscillator with internal R and C to generate 32±20%KHz clock. Its power supply is 3.3V....
2303
1.0
CSMC 0.13um 32KHz Crystal Oscillator
This is a 32768Hz crystal oscillator specifically designed for ultra-low power application. The sole power supply is 3.3V, but it can be as low as 1.6...
2304
1.0
GSMC 0.13um 5v-1.5v Power Regulator
This IP is a Low-Dropout (LDO) 5V to 1.5V power regulator with two channel outputs. The max output currents are 50mA (for VD15A output) and 40mA (for ...
2305
1.0
GSMC 0.13um 5v-3.3v&1.5v Power Regulator
This IP is a Low-Dropout (LDO) 5V to 3.3V&1.5V power regulator in GSMC 0.13um low power 4P5M e-flash dual gate process. The max output currents are 60...
2306
1.0
CSMC 0.13um 5v-3.3v/1.2v Battery Charger
Based on CSMC 0.13um 3.3V/1.2V Logic process, current design of the Battery Charger IP is a complete constant current/constant voltage linear charger ...
2307
1.0
CSMC 0.13um 8-Bit 4-Input 200k SAR ADC
This analog-to-digital converter uses Successive Approximation Register (SAR) architecture to achieve 8-bit resolution. The IP includes 4-1 MUX and a ...
2308
1.0
CSMC 0.13um Generic Process Programmable Gain Amplifier
The CS13V33_PGA_02 integrates two 2-channel programmable gain amplifiers It is always combined with audio ADC or audio DAC to pre-amplify analog input...
2309
1.0
GSMC 0.13um Low Power e-Flash 1.5V POR
This IP is a Power-On-Reset circuit, it detects the voltage level of POR_VDDC port, when VPOR_VDDC rises higher than the threshold VPOR, POR outputs a...
2310
1.0
GSMC 0.13um Low Power Process Delay Cells
G13LPV33_DELAYRC_01 is to generate rise/fall delay ranging from 0.15ns to 5ns....
2311
1.0
TSMC 0.13um LVDS Transmitter
The LVDS transmitter is designed to support Single Link transmission between Host and Flat Panel Display with up to SXGA+ resolution and Dual Link tra...
2312
1.0
CSMC 0.13um USB 1.1 PHY
The USB1.1 PHY is an IP version of USB transceiver designed in standard logic to interface the physical layer of Universal Serial Bus. It receives dat...
2313
1.0
GSMC 0.13μm Low Power Process 2.6~3.63v -> 1.5v Power Regulator
Targeted in GSMC 0.13μm Low Power 1.5V/3.3V 1P6M process, current design of Power Regulator is to provide 1.5v power supply which is regulated from th...
2314
1.0
GSMC 0.13μm Low Power Process VCC Detector
This IP contains two Voltage Detector (VDT) circuits and a Power-On-Reset (POR) circuit. The voltage detectors monitor the supply voltage of Bus Suppl...
2315
1.0
GSMC 0.18um 1.8v APLL
The GSMC18_PLL_01 is developed as a macro cell for clock generation. It can generate a stable high-speed clock from a slower clock signal. The output ...
2316
1.0
CSMC 0.18um 1.8v APLL
This IP is a programmable Analog PLL suitable for high speed clock generation. High speed VCO can run from 300MHz to 600MHz. By setting DM[4:0] and DN...
2317
1.0
GSMC 0.18um 1.8v POR
The present IP is a Power On Reset (POR) circuit without external resistors or capacitors. Its power supply is 1.8v....
2318
1.0
GSMC 0.18um 1.8v RC Oscillator
The present IP is a RC oscillator with one external resistor to generate 25~50 MHz clock. Its power supply is 1.8v....
2319
1.0
GSMC 0.18um 1.8v RC Oscillator
The present IP is a RC oscillator with one external resistor to generate 25~50 MHz clock. Its power supply is 1.8v....
2320
1.0
GSMC 0.18um 1.8v Ring Oscillator
The present IP is a Ring Oscillator. Its output frequency is about 55 MHz. The frequency can be fairly accurate (+/-10%) by trimming the resistance. I...
2321
1.0
GSMC 0.18um 1.8v Ring Oscillator
The present IP is a Ring Oscillator. Its output frequency can be changed by adjusting the external resistor. Its power supply is 1.8v +/-10%. A bandga...
2322
1.0
GSMC 0.18um 1.8v Ring Oscillator
The present IP is a Ring Oscillator. Its power supply is 1.8v ±10% and the output frequency CLK is about 40 MHz. The frequency can be fairly accurate ...
2323
1.0
GSMC 0.18um 11Bit 500Ksps R2R DAC
GSMC18_R2RDAC_04 is a 11Bit 500KHz DAC IP. It implements an 8-bit (from D [0] to D [7]) R2R_Ladder and 3-bit thermometer decoder architecture. It is s...
2324
1.0
GSMC 0.18um 3.3v
This IP is a programmable Analog PLL suitable for high speed clock generation. High speed VCO can run around 100MHz. By setting different values of DM...
2325
1.0
GSMC 0.18um 3.3v APLL
Present IP is a programmable Analog PLL suitable for high speed clock generation. High speed VCO can run from 150MHz to 266MHz. By setting different v...
2326
1.0
GSMC 0.18um 3.3v APLL
This IP is a programmable Analog PLL suitable for high speed clock generation. High speed VCO can run from 300MHz to 600MHz. By setting different valu...
2327
1.0
GSMC 0.18um 3.3V Power on Reset
The present Power-On-Reset circuit generates system reset pulses (RST) when the power supplier is from 1.62V to 3.6V. The output signal RST is positiv...
2328
1.0
GSMC 0.18um 3.3v RC Oscillator
The present IP is a RC oscillator with internal R and C to generate 32¡À20%KHz clock. Its power supply is 3.3V....
2329
1.0
GSMC 0.18um 3.3v RC oscillator with internal R and C to generate 32±20%KHz clock.
The present IP is a RC oscillator with internal R and C to generate 32KHz±30% clock. Its power supply is 3.3V....
2330
1.0
GSMC 0.18um 3.3V Trimming Block
This IP is suitable for voltage trimming. It provides 2 effuse bits, TRIM[1:0]. Before trimming, TRIM[1:0] are set to 1.8V and the output ports are hi...
2331
1.0
GSMC 0.18um 3.3v-1.8v Power Regulator
This is a 3.3V to 1.8V power regulator based on GSMC 0.18um 1.8V/3.3V D0 Process. In regulated region, the rated output current is <20mA....
2332
1.0
GSMC 0.18um 3.3v-1.8v Power Regulator
Power Regulator, also called Voltage Regulator, is an on-chip device which provides suitable power supply for the core from an external high voltage p...
2333
1.0
GSMC 0.18um 3.3v-1.8v Power Regulator
Power Regulator, also called Voltage Regulator, is an on-chip device which provides suitable power supply for the core from an external high voltage p...
2334
1.0
GSMC 0.18um 3.3v-1.8v Power Regulator
Power Regulator, also called Voltage Regulator, is an on-chip device which provides suitable power supply for the core from an external high voltage p...
2335
1.0
GSMC 0.18um 3.3v-1.8v Random code generator circuit, internal pattern frequency is 750MHz, sampling clock upto 250MHz.
GSMC18_RCG_03 is to generate random code with the sampling clock up to 250MHz....
2336
1.0
GSMC 0.18um 3.3v/1.8v 80mA power regulator
Present project is a regulator that generates 1.8v voltage from 3.3v power supply. Based on the GSMC 0.18um 3.3v process, it provides a maximum curren...
2337
1.0
GSMC 0.18um 3.3v/1.8v Power Regulator
Present project is a regulator that generates 1.8v voltage from 3.3v power supply. Based on the GSMC 0.18um 3.3v process, it provides a maximum curren...
2338
1.0
GSMC 0.18um 5v-3.3v Power Regulator
This IP is a Low-Dropout (LDO) 5V to 3.3V power regulator in GSMC 0.18um 3.3V/1.8V Logic process. When it works in regulation region, the max rated ou...
2339
1.0
GSMC 0.18um 5v-3.3v/1.8v Power Regulator
Based on GSMC 0.18um 3.3v/1.8v Logic process, current design of the Power Regulator is to provide both 3.3v and 1.8v power supplies which are regulate...
2340
1.0
GSMC 0.18um General Process, Low Power circuit design, Diffusion ROM
Based on GSMC 0.13um 1.5V/12V eFlash process, current design of the IP detects light with photodiode. When the incident light power is more than 70mW/...
2341
1.0
GSMC 0.18um Power-On Reset
This is a Power-On-Reset circuit that generates a reset pulse when power supply is on. After the power V18 reaches a specific level, i.e., VTR, it wil...
2342
1.0
GSMC 0.18um VCC Detector
The present IP is a VCC Detector (VDT) circuit. It detects the voltage level of its power supplies, AV18 and AV33. The normal operation voltage levels...
2343
1.0
GSMC 0.18um VCC Detector
The present IP is a VCC Detector (VDT) circuit which detects the core supply and then sends a corresponding control signal to level shift. In specific...
2344
1.0
GSMC 0.18um VCC Detector
The present IP is a VCC Detector (VDT) circuit. It detects the battery voltage level. It will generate two flag signals, VBT21 and VBT36, when VBT3 re...
2345
1.0
GSMC 0.18um VCC Detector
The present IP is a VCC Detector (VDT) circuit. It detects the voltage level of both core (AVDD18) and I/O (AVDD33). It will generate four flag signal...
2346
1.0
GSMC 0.18um Voltage Detector
The present IP is a Voltage Detector (VDT) circuit. Its power supply is 2.7v~3.6v....
2347
1.0
GSMC 0.18um Voltage Detector
The present IP devise a Voltage Detector (VDT) circuit. With the help of a 1.2v input reference, it detects both 3.3v and 1.8v input voltages and it w...
2348
1.0
GSMC 0.18um Voltage Detector
This IP is a Voltage Detector (VDT) circuit for power management application. When the supply voltage (AVDD33) increases above the detection level (VT...
2349
1.0
GSMC 0.18um Voltage Detector
The present IP is a Voltage Detector (VDT) circuit. When the voltage is in the range of VTHL to VTHH, the output, OUT_RD, is generated as a high level...
2350
1.0
GSMC 0.18um Voltage Detector
This IP is a Voltage Detector (VDT) circuit for power management application. When the supply voltage (AVDD33) increases above the detection level (VT...